Sending and Receiving Bulk Messages

In TL1 Craft Interface, one or more messages can be selected to be sent at a time. This section explains how to perform this function from the Craft Interface. At present, the bulk mode is supported only in Data Set and Text file.

To send multiple commands at the same time:

1. Load a Data Set or Text file.

2. Select commands from the data set or list with Ctrl button pressed. All selected commands will be displayed in the right panel under List of all Messages.

3. Select the commands in the order they have to be sent and press the >> button. These commands will be put in the send list.

4. Use the << button to remove selected commands from the send list.

5. Choose the mode of transmission (Synchronous/Asynchronous).

6. Click the Start button or Send Bulk Messages button to send the commands. The responses can be viewed in the right panel.

7. Use the Pause button to pause the send operation. You can click the Resume button to resume the operation again.

8. Use the Stop button to stop the send operation.